6.4.1
Fitting the grinding wheel
WARNING
Risk of injury. The accessory tool may work loose due to the braking effect of the motor.
▶ Wait until the accessory tool has come to a standstill before touching or gripping the accessory tool or
the clamping nut.
▶ Secure the accessory tool by tightening the clamping flange and clamping nut firmly so that no parts
work loose from the spindle due to the braking effect of the motor.
1. Check that the O-ring is in place in the clamping flange and that it is undamaged.
Result
The O-ring is damaged.
There is no O-ring in the clamping flange.
▶ Fit a new clamping flange with O-ring.
2. Fit the clamping flange on to the drive spindle.
3. Fit the grinding wheel.
4. Screw on the clamping nut corresponding to the type of accessory tool installed.
5. Press the spindle lock button and hold it in this position.
6. Use the pin wrench to tighten the clamping nut securely, then release the spindle lock button and remove
the wrench.
6.4.2
Removing the grinding wheel
WARNING
Risk of breakage and irreparable damage. If the spindle lockbutton is pressed while the spindle is
rotating, the accessory tool can detach from the power tool.
▶ Press the spindle lockbutton only when the spindle has stopped rotating.
1. Press the spindle lock button and hold it in this position.
2. Release the clamping nut by gripping it with the wrench and turning the nut counterclockwise.
3. Release the spindle lock button and remove the grinding wheel.
6.4.3
Fitting a grinding wheel with a Kwik lock nut
WARNING
Risk of breakage. Heavy wear (abrasion) may cause the Kwik lock nut to break.
▶ When working with the power tool, make sure that the Kwik lock nut doesn't come into contact with the
working surface.
▶ Do not use a damaged Kwik lock nut.
The optional Kwik lock nut can be used instead of the standard clamping nut. Grinding wheels can
then be changed without the need for additional tools.
1. Clean the clamping flange and the quick-release clamping nut.
2. Check that the O-ring is in place in the clamping flange and that it is undamaged.
Result
The O-ring is damaged.
There is no O-ring in the clamping flange.
▶ Fit a new clamping flange with O-ring.
3. Fit the clamping flange on to the drive spindle.
4. Fit the grinding wheel.
5. Screw on the Kwik lock nut until it is seated against the grinding wheel.
▶ The name Kwik lock should be visible when the nut is screwed on.
6. Press the spindle lock button and hold it in this position.
7. Firmly turn the grinding wheel clockwise by hand until the Kwik lock nut is tightened securely and then
release the spindle lock button.
12
English
8
9
2381083
*2381083*