Hilti AG 600-20D Manual De Instrucciones página 16

Equipment
Item
Kwik lock
H
(optional for F)
Clamping nut
I
(abrasive resin-fiber
wheel)
Support plate
J
(abrasive resin-fiber
wheel)
K Guard type 27
4 Product information
For rated voltage, rated current, frequency and/or input power, refer to the rating plate.
If the product is powered by a generator or transformer, the generator or transformer's power output must
be at least twice the rated input power shown on the rating plate of the product. The operating voltage of
the transformer or generator must always be within +5 % and -15 % of the rated voltage of the product.
ATTENTION! For working with a 150 mm accessory tool, a 150 mm guard (supplied separately) must
be used.
Product generation
Rated speed under no load
Maximum wheel diameter
Drive spindle thread
Spindle length
Weight
Ambient temperature for operation
Storage temperature
5 Use of extension cords
Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
10 English
AG-D
AC-D AP-D AF-D
AN-D
✓ — ✓
— ✓ —
— ✓ —
— — —
AG 600­20D
01
10,000 /min
6 in
5/8"-11
22 mm
2.5 kg
(5.5 lb)
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
DG-CW DC-D 3CS/4CS
(SPX/ (SPX/ 3SS/4SS
SP/P) SP/P)
— ✓ —
— — —
— — —
— — —
2381083
*2381083*
AG-D
5⁄8"-11
—
—
—
✓