Gardena ZoneProtect Instrucciones De Empleo página 15

1. Remove the cover
2. Fold open the sealing cap
3. Plug the USB-C plug of the supplied charg-
ing cable into the charging socket
4. Plug the USB-A plug of the charging cable
into the power supply unit.
5. Connect the power supply unit into a mains
socket.
The battery is charging and the LED
blinks orange.
When the battery is fully charged, the LED
illuminates orange. When the battery is
fully charged, the ZoneProtect works for
approx. 31 days.
LED indicators [ Fig. O2 ]:
By briefly pushing the button
ZoneProtect is displayed for 5 seconds.
illuminates green Activated and battery capacity
> 30 %
blinks green Activated and battery capacity
< 30 %
flashes green Activated and battery capacity
< 10 %
illuminates orange Battery is fully charged
blinks orange Battery is charging
illuminates blue Zone cable is not connected or
cut and battery capacity > 30 %
blinks blue Zone cable is not connected or
cut and battery capacity < 30 %
flashes blue Zone cable is not connected or
cut and battery capacity < 10 %
illuminates purple Mower is in ECO Mode, boundary
cable is not detected or invalid zone
range and battery capacity > 30 %
GAR_15021-20.960.05_2024-04-30.indd 15 GAR_15021-20.960.05_2024-04-30.indd 15
(9)
.
(1)
.
(C)
.
(L)
(L)
(8)
the status of
blinks purple Mower is in ECO Mode, boundary
cable is not detected or invalid
zone range and battery capacity
< 30 %
flashes purple Mower is in ECO Mode, boundary
cable is not detected or invalid
zone range and battery capacity
< 10 %
illuminates red Error and battery capacity > 30 %
(see 6. TROUBLESHOOTING)
blinks red Error and battery capacity < 30 %
(see 6. TROUBLESHOOTING)
flashes red Error and battery capacity < 10 %
(see 6. TROUBLESHOOTING)
flashes white Push the button
5 times every status is displayed
10 sec
blinks white ZoneProtect switches off
In order to achieve the maximum runtime of
the ZoneProtect, the mower must be operated
in Eco mode (see Operator's manual of the
robotic lawnmower).
To switch on the ZoneProtect
[ Fig. O2 ]:
(8)
Push the button for 2 seconds.
v
The ZoneProtect is switched on and
(L)
the LED illuminiates / blinks green
(depending on the battery capacity).
To switch off the ZoneProtect
[ Fig. O2 ]:
(8)
Push the button for 2 seconds.
v
The ZoneProtect is switched off and
(L)
the LED blinks white.
(8)
so that the
15
30.04.24 09:52 30.04.24 09:52