Publicidad
Idiomas disponibles
Idiomas disponibles
Installing and Removing the Battery Pack From the Tool
CAUTION:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery pack
into tool until an audible click is heard as shown in
figure C.
TO REMOVE BATTERY PACK: Depress the
battery release button as shown in figure D and
pull battery pack out of tool.
Operating Instructions
Trigger Switch & Forward/Reverse Button - Figure E
•
The drill is turned ON and OFF by pulling and
releasing the trigger switch (1) shown in
figure E. The farther the trigger is depressed,
the higher the speed of the drill.
A forward/reverse control button (2) determines
•
the direction of the tool and also serves as a
lock off button.
•
To select forward rotation, release the trigger
switch and depress the forward/reverse control
button on the right side of the tool.
•
To select reverse, depress the forward/reverse
control button on the left side of the tool.
•
The center position of the control button locks
the tool in the off position. When changing the position of the control button, be sure
the trigger is released.
When drill is activated by pulling the trigger switch (1), the integrated LED work light
LED Work Light
(9) will automatically illuminate the work area. NOTE: The work light is for lighting the
immediate work surface and is not intended to be used as a flashlight.
C
D
E
9
2
1
Publicidad
