Würth AFP 18-A Manual De Instrucciones página 13

IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER & BATTERY PACK
1. Caution To reduce risk of injury, charge only
specific type rechargeablebattery packs. Other
types of battery packs may burst causing
personal injury and damage.
2. Before using charger, read all instructions and
cautionary markings on battery packs and
chargers.
3. Do not expose charger to rain or snow.
4. To reduce the risk of damage to electric plug and
cord, pull by plug rather than cord when
disconnecting charger.
5. Use of an attachment not recommended or sold
by the charger manufacture may result in a risk of
fire, electric shock, or injury to persons.
6. Make sure cord is located so that it will not be
stepped on, tripped on, tripped over, or otherwise
subjected damage or stress.
7. Do not operate charger with damaged cord or
plug. Replace them immediately.
8. Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damage in any
way, take it to qualified center.
9. To reduce risk of electric shock, unplug charger
from outlet before attempting any maintenance or
cleaning. Turning off controls will not reduce this
risk.
10. Do not disassemble charger or battery pack,
take it to a qualified service center while repair is
required. Incorrect reassembling may result in a
risk of electric shock or fire.
ADDITIONAL SAFETY RULES FOR
CHARGER & BATTERY PACK
1. Do not charge battery pack when temperature
is below 10°C (50°F) or above40°C (104°F).
2. Do not attempt to use a set-up transformer, an
engine generator or DC power receptacle.
3. Do not allow anything to cover or clog the
charger vents.
4. Always cover the battery pack terminals with the
battery pack cover when the battery pack: is not
used.
5. Do not short the battery pack.
6. Do not touch the terminals with any conductive
material.
7. Avoid storing battery pack in a container with
other metal objects such as nails, coins, etc.
8. Do not expose battery pack to water or rain, A
battery pack short can use large current flow,
overheating, possible
burns and even a breakdown.
9. Do not store the machine and battery pack in
locations where the temperature may reach or
exceed 50°C (122°F)
10. Do not incinerate the battery pack even if it is
severely damaged or completely worn out. The
battery pack can explode in a fire.
11. Be careful not drop, shake or strike battery pack.
12. Do not charge inside a box or container of any
kind. The battery pack must be placed in
a well ventilated area during charging.
13. Do not leave batteries unused for extended
period of time. Recharge the battery every
3~6 months and bring Li-Ion battery to
40~80% charge level before storage.
14. Li-Ion batteries are sensitive to high temperature
and should be kept in a cool,dry and out of
direct light exposure. Ideal temperature for
operation and storage is below 77°F.
15. For extension of the battery lifetime, the
lithium-ion battery is designed with the
protection function to stop the output.
In the case of described below, when using this
product, even if you are pulling the switch, the
motor may stop. This is not malfunction but
the result of protection function.
16. When the battery power remaining runs out, the
motor stops.
17. If the tool is overloaded, the motor may stop.
In this case, release the switch of tool and
eliminate causes of overloading.
After that you can use it again.
18. If the battery is overheated under overload work,
the battery power may stop. In this case stop
using the battery and let the battery cool.
After that you can use it again.
13