Würth AFP 18-A Manual De Instrucciones página 16

Suction Filling(From Bulk Container)
1. Unscrew and dis-assemble tube cap from the
container tube as Fig.5
2. Visually check the direction of plunger lip. Fig.2
3. Change the lip direction of plunger by your finger.
The lip must be directed toward
the gun head.
4. Screw and re-assemble tube cap from the contai-
ner tube.
5. Insert the open end of grease container ass'y into
lubricant of bulk container.
Draw back piston rod slowly while pushing the grea-
se container ass'y deeper
into the lubricant to prevent air pocket. See Fig.6
6. When piston rod is fully extended, latch the groo-
ve of piston rod into the slot of
tube cap.
7. Screw grease container ass'y into gun.
8. Release the piston rod from slot and push it all the
way in.
9. This gun is ready to use. If your gun fails to work,
to remove the air, procedure
as Remove Air Pocket .
Loading With Filler Pump
1. Set the plunger in Engaging . See Fig.4
2. Fit the filler plug Fig.7 with the socket of filler
pump.
3. Piston rod will be extended fully when the level of
16
filler pump is operated. See
Fig.8
4. Set the plunger in Disengaging . Push piston rod
all the way in.