Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Selecting the installation equipment
Cut out the work surface according to the dimensions shown in the illustration.
For installation and use, you must maintain a minimum clearance of 5 cm around the opening. Make
sure that the thickness of the work surface is at least 30mm. Please choose heat-resistant and insulated
materials for the work surface (wood and other similar fibrous or hygroscopic materials should not be
used as work surface material unless they are waterproofed) to avoid electric shock and further
deformation caused by heat radiation from the hob. As shown below:
x
L(mm)
W(mm)
590
520
Note: Make sure that the hob is well ventilated and that the air inlet and outlet are not blocked. Make
sure that the hob is in good working order. As shown below.
Note: The recommended safety distance between the hob and the cabinet above the hob should be at
least 550mm - 650mm for ceramic and induction hobs, and 650mm - 750mm for gas hobs.
L
H
D
B
x
H(mm)
D(mm)
51
47
W
x
A
A(mm)
B(mm)
560±2
480±2
35
SEAL
F
Min. 3mm
X(mm)
F(mm)
50 mín.
3 mín.
English
infiniton.es
Publicidad
