Metabo HPT C 3610DRA Manual De Instrucciones página 33

Sierra ingletadora deslizante inalambrica
Ocultar thumbs Ver también para C 3610DRA:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(2) Setting to cut crown moldings at positions 2 and 3
in Fig. 38 (see Fig. 40; tilt the head to the left):
1 Turn the turntable to the left and set the Miter Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
2 Tilt the head to the left and set the Bevel Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
3 Position the crown molding so that the lower surface
(Ⓑ in Fig. 37) contacts the fence as in Fig. 42.
Head
1
Miter angle
scale
Turntable
2
Fence (B)
Base
35.3°
31.6°
30°
33.9°
Bevel angle scale
4
Fence (A)
Base
Fig. 39
Head
Bevel angle scale
3
Miter angle scale
Turntable
Fig. 40
Fence
Fence
(3) Setting to cut crown moldings at positions 1 and 4
in Fig. 38 (see Fig. 43; tilt the head to the right):
1 Turn the turntable to the right and set the Miter Angle
as follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
3 Position the crown molding so that the upper surface
(Ⓑ in Fig. 37) contacts the fence as indicated Fig. 45.
(4) Setting to cut crown moldings at positions 2 and 3
in Fig. 38 (see Fig. 44; tilt the head to the right):
1 Turn the turntable to the left and set the Miter Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
3 Position the crown molding so that the lower surface
(Ⓐ in Fig. 37) contacts the fence as in Fig. 46.
English
Table on base
Fig. 41
Table on base
Fig. 42
35.3°
31.6°
30°
33.9°
35.3°
31.6°
30°
33.9°
33

Publicidad

Tabla de contenido
loading

Tabla de contenido