Publicidad
Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
Problem
The food is not
frozen enough.
Heavy build up of
frost on the door
seal.
Unusual noises
Water on the floor
Side panels are
hot.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here,
refer to the rating plate.
Possible Cause
• Temperature is not
properly adjusted.
• Door was open for
an extended period.
• A large quantity
of warm food
was placed in the
appliance within the
last 24 hours.
• The appliance is
near a heat source.
• Door seal is not air
tight.
• Appliance is not
level.
• The appliance is
touching the wall or
other objects.
• A component, e.g.
a pipe, on the rear
of the appliance
is touching
another part of the
appliance or the
wall.
• Water drain hole is
blocked.
• It's normal. Heat
exchange parts are
in the sides.
18
Solution
• Please look in the initial Temperature
Setting section.
• Open the door only as long as
necessary.
• Turn the temperature regulation to a
colder setting temporarily.
• Please look in the installation
location section.
• Carefully warm the leaking sections
of the door seal with a hair dryer
(on a cool setting). At the same time
shape the warmed door seal by hand
such that it sits correctly.
• Re-adjust the feet.
• Move the appliance slightly.
• If necessary, carefully bend the
component out of the way.
• See the Cleaning and maintenance
section.
• Take gloves to touch sides if needed.
EN
Publicidad
