Parkside PAT 4 D5 Traduccion Del Manual De Instrucciones Originale página 46

Note: Use the window on the fill indicator
magazine
4
Functions
Stapling & Nailing
Set the On/Off switch
Press the safety contact
Squeeze the trigger
Make sure to keep the product pressed against the work piece.
Set the On/Off switch
product off.
Note: Hold tool firmly and press on work surface before firing to
ensure the complete penetration of the staple/nail.
Clearing Jammed Staples
It may otherwise accidentally be triggered after removing the staple.
Note: Set the On/Off switch
jammed staple.
Open the magazine
Remove the jammed staple from the magazine
Note: Do not trigger the staple gun when empty to prevent wear.
Determining the Staple Length
Consider two factors when determining the correct staple length:
- the thickness of the material being fastened
- the composition (hardness) of the material being fastened.
46 GB/IE
is empty.
to the "I" position to switch the product on.
8
into the work piece.
6
to drive a staple/nail into the work piece.
1
to the "0" position to switch the
8
If a staple is jammed, do not squeeze the trigger
to "0" position prior to clearing the
8
and pull back on the pusher
4
to see if the
5
.
3
.
4
.
1