SEVERIN KS 9837 Instrucciones De Uso página 12

Familiarisation
1. Temperature control (at the rear)
2. Vapouriser with storage rack
3. Adjustable front feet
4. Door
Before using for the fi rst time
∙ Remove any exterior and interior packaging materials
completely, including the adhesive strips.
∙ Before it is connected to the mains, the unit must be
thoroughly checked for transport damage, including its
power cord.
∙ Clean the unit according to the instructions given in the
De-frosting and cleaning section below.
∙ The unit should only be transported in its vertical position;
do not tilt any more than 30°.
∙ Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
∙ If the unit has been tilted more than 30° during transport,
allow it to stand upright for at least 4 hours before it is
connected to the mains.
∙ When the unit is fi rst switched on, a slight smell may be
noticed. However, this will disappear once the cooling
process has begun.
Installation
∙ The appliance should be set up in a well-ventilated, dry
room.
∙ It should be operated in conditions where the relative
humidity is no more than 70 %.
∙ The product data sheet at the end of this manual contains
details of the ambient temperature range suitable for this
appliance.
∙ Do not use the appliance outdoors.
∙ Ensure that the plug is accessible and can be removed
from the wall socket at any time.
∙ Do not expose the appliance to direct sunlight, and
do not position it next to any heat sources (radiators,
cookers etc.). If this cannot be avoided, however, suitable
insulation must be in installed between the heat source
and the unit.
∙ The unit must not be installed inside a cabinet, nor
directly below a hanging cupboard, shelf or similar object.
∙ In the case of uneven fl oors, the adjustable foot on the
unit can be used to compensate and ensure optimum
12
stability.
Ventilation
Ensur e that there is enough space around the unit so that
the air circulation round and behind it is not obstructed.
(Rear 7.5 cm, sides 5 cm, top 10 cm.)
Reversible door
If required, the door may be reversed, i.e. from right-hinged
(default installation) to left-hinged.
Warning: Always disconnect the unit from the mains before
any maintenance or repair work is carried out.
1. Remove the hinge cover (1).
2. Use a suitable pointed tool to remove the cover (5).
3. Use a suitable screw-driver to remove the two screws
(2) holding the upper hinge (3) to the housing.
4. Carefully lift up the door and place it on a soft surface
to protect it from scratches.
5. Remove the blind covers for the hinge mounting holes
(9) and fi t it in the corresponding place on the right.
Ensure that the cover is fi rmly pushed down into the
hole.
6. Pull out the two screws (7) which hold the lower right
hinge plate (4) and the adjustable foot (6) in position.
Take off the hinge plate (4) and the adjustable foot (6)
and replace and tighten the two screws again.
7. Remove the adjustable foot (8) on the left and insert it
into the corresponding thread on the right.
8. Unscrew the two screws on the left-hand side and
install the lower hinge plate (4) with the two screws (7)
on this side. Caution: Do not yet tighten the screws.
9. Replace the door in its new position. Ensure that the
hinge pin is inserted into the guide bushing (hole) on
the lower part of the door.