Sony HT-SS380 Manual De Instrucciones página 30

Tuning to a station
automatically (Automatic
Tuning)
1
Press TUNER.
2
Press TUNING + or TUNING –.
TUNING + scans from lower to higher
frequency stations and TUNING – for
scanning higher to lower.
The receiver stops scanning whenever a
frequency is received.
In case of poor FM stereo
reception
If the FM stereo reception is poor and "ST"
flashes on the display panel, select monaural
audio to lessen the sound distortion.
1
Press AMP MENU.
2
Press V/v repeatedly until "TUNER"
appears, then press
3
Press V/v repeatedly until "FM MODE"
appears, then press
4
Press V/v repeatedly until "MONO"
appears, then press
To return to stereo mode, repeat steps 1 to 4
and select "STEREO" in step 4.
Tip
To improve reception, reorient the supplied FM wire
antenna (aerial).
30
US
or b.
or b.
.
Tuning to a station directly
(Direct Tuning)
You can enter the frequency of a station
directly by using the numeric buttons.
1
Press TUNER.
2
Press D.TUNING.
3
Hold down SHIFT, then press
the numeric buttons to enter
the frequency.
Example: FM 102.50 MHz
Select 1 b 0 b 2 b 5
4
Hold down SHIFT, then press
ENTER.
If a wrong frequency is entered
"FM ---.--" appears and then the display
returns to the current frequency.
If you cannot tune to a station
Make sure you have entered the right
frequency. Try repeating steps 2 to 4. If you
still cannot tune in a station, the frequency
may not be in use in your area.