Using The Tuner - Pioneer X-CM56 Manual De Instrucciones

07

Using the tuner

Chapter 7:
Using the tuner
Listening to FM (X-CM56D)/
Listening to FM or AM (X-CM56)
The following steps show you how to tune in to FM and AM
radio broadcasts using the automatic (search) and manual
(step) tuning functions. Once you are tuned to a station you
can memorize the frequency for recall later. See Saving
station presets below for more on how to do this.
Tuning
1 Press the Í to turn the power on.
2 Press TUNER repeatedly to select desired
frequency band (FM or AM).
• (X-CM56D) You can select "FM" and "DAB".
For details about "DAB", see page 25.
3 Press TUNE +/– on the remote control to
tune in to the desired station.
Automatic tuning:
Press and hold TUNE +/–, scanning will start automatically
and the tuner will stop at the first receivable broadcast
station.
Manual tuning:
Press the TUNE +/– repeatedly to tune in to the desired
station.
Note
• When radio interference occurs, automatic tuning may
stop automatically at that point.
• Automatic tuning will skip weak signal stations.
• To stop the automatic tuning, press ∫.
• When an RDS (Radio Data System) station is tuned in,
the frequency will be displayed first. Finally, the station
name will appear.
• Full auto tuning can be achieved for RDS stations using Auto
Station Program Memory (ASPM) mode, see page 24.
22
En
To receive an FM stereo transmission:
1 Press TUNER until "FM" appears on the display.
2 Press MENU and then press
MONO" appears on the display.
3 Press ENTER and then press
appears on the display.
Improving poor FM reception:
After performing the above steps 1 - 2, press ENTER and
then press / until "MONO" appears on the display.
This will change the tuner from stereo to mono and usually
improve the reception.
Saving station presets
If you often listen to a particular radio station, it's convenient
to have the receiver store the frequency for easy recall
whenever you want to listen to that station (Preset tuning).
This saves the effort of manually tuning in each time. This
unit can memorize up to 45 stations.
(FM 30 stations/AM 15 stations)
1 Tune to a station you want to memorize.
See Tuning above for more on this.
2 Press PGM/MEMORY.
The preset number will flash.
3 Press PRESET +/– to select the preset
channel number.
4 Press PGM/MEMORY to store that station
in memory.
If the preset number has changed from flashing to lighting,
before the station is memorised, repeat the operation from
step 2.
• Repeat steps 1 - 4 to set other stations, or to change a
preset station. When a new station is stored in the
memory, the station previously memorised for that
preset channel number will be erased.
/ until "FM STEREO/
/ until "AUTO"