Operating The Optional Solution Tank - Tennant 2100 Serie Manual De Operador Y Lista De Repuestos

EN OPERATION
5. To begin scrubbing, hold the handles firmly,
depress the safety lock levers and pull the On/Off
levers. Release safety lock lever once machine
starts (Figure 12).
ATTENTION: Use caution when starting out, the
machine will jolt when the On/Off levels are
activated.
FIG. 12
6. To move the machine left (A), slightly lower the
handle. To move right (B), slightly raise the
handle. Operate the machine with a side to side
motion (Figure 13).
A
FIG. 13
7. To stop machine, release the On/Off levers and
hold handles firmly until machine comes to a
complete stop. The safety lock lever will
automatically engage.
FOR SAFETY: When using machine, do not
release handle grips until pad comes to a
complete stop.
8. Do not operate the machine in the same spot for a
long period of time. Floor damage may result.
8
B
Home Find... Go To.. Home Find... Go To..
9. To maneuver over thresholds and floor grates,
stop the machine and tilt it back on the transport
wheels.
10. When machine is not in use, do not leave machine
standing on the pad/brush. Pad/brush damage
may result.
11. When done scrubbing perform the following
machine maintenance procedures.

OPERATING THE OPTIONAL SOLUTION TANK

1. Remove cover and fill the solution tank with a
recommended solution. Replace cover after filling.
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
2. Lower handle to working position. Pull the solution
control lever to disperse solution to the pad/brush
(Figure 14).
FIG. 14
2100/2120/2140/2150/2200/2260 (07–03)