Removing Pad Driver Or Brush; Filling Solution Tank - Tennant 5100 Manual Del Operador

OPERATION

REMOVING PAD DRIVER OR BRUSH

1. Raise scrub head to transport position. Step down
firmly on scrub head lift pedal to raise (Figure 11).
FIG. 11
2. Turn main power switch on.
3. Tilt machine back on it's rear wheels.
4. While pressing the "brush release button", pull and
release the brush trigger quickly. The pad
driver/brush will automatically spin off motor hub.
If it doesn't release, repeat step (Figure 12).
FIG. 12
NOTE: To prevent scrub head skirt damage, always
keep machine in transport position when pad driver or
brush is not installed.

FILLING SOLUTION TANK

1. Transport machine to filling station. Raise
squeegee and scrub head when transporting.
2. Turn off main power switch.
3. Remove solution tank fill port cover.
4. Fill solution tank with 7.5 gallons (28L) of clean
water (140°F/60°C max.) (Figure 13).
8
Home Find... Go To..
FIG. 13
NOTE: If filling with a bucket be certain that bucket is
clean. This will prevent possible solution line clogs.
5. Add cleaning chemical. See proper dilution ratio
instructions on chemical container.
6. Replace solution tank fill port cover.
ATTENTION: Use only recommended detergents.
Machine damage due to improper detergent usage
will void the manufacturer's warranty. Contact
your Sale Representative for detergent
recommendations.
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
7. If machine is equipped with ESt (Extended
Scrub) option, the recovery tank can be partially
filled to extend scrub time.
a. Remove recovery tank lid and fill tank with 3.5
gallons (13L) of clean water (140°F/ 60°C
maximum temperature). Close lid.
b. Turn on ESt switch when operating machine
(Figure 14).
FIG. 14
c. The ESt light will glow when the ESt pump
is recycling.
Tennant 5100 (05- -05)