Ordering Replacement Parts; Disposal And Recycling - EINHELL 34.006.28 Manual De Instrucciones

7.2.3 Changing / rotating the clearing bar
(Fig. 3)
When changing the clearing bar, be sure to use
only genuine replacement parts. To dismantle the
clearing bar undo the screws around the snow
plow blade and remove the counter pressure bar.
Replace the old clearing bar with a new one and
install in reverse order.
Important! After the one side of the clearing bar
has been worn down, it can be rotated by 180° for
continued use.
Damaged clearing bar or damaged blade
If, in spite of all caution, the blade comes into
contact with an obstacle, switch off the engine
immediately and actuate the locking brake. Check
the clearing bar and blade for damage. Damaged
or bent parts must be replaced or repaired. Impor-
tant: Risk of injury when working with a damaged
snowplow blade.
Worn or damaged skids
Replace strongly worn skids. It may be possible to
repair bent skids by aligning them.

7.3 Ordering replacement parts

Please provide the following information on all
orders for spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
Anl_Schneeschild_SPK7.indb 15 Anl_Schneeschild_SPK7.indb 15
GB
- 15 -
17.10.14 10:30 17.10.14 10:30