Safety Information; Technical Data - Hedson DRESTER QR-TT Manual Del Usuario

Follow the sequence of pictures at the end of this manual.
Change of water (left side of the unit):
Pull the suction hose from the pump out of the container under the unit and refill it with fresh Water.
Put the container back under the unit and insert the suction hose from the pump all the way down.
Empty the container for return water under the unit into a suitable unit where the return water can be separated from the paint
residuals by using the "Floculation technology", after wich the return water can be drained off into a regular drain water system
(this must however be confirmed by the local water authoroties). Such units are the DRESTER gun cleaner units 1000, 950,1050,
9000-TT, 1200 and 2000-TT.
Put the container back under the machine and insert the drainhose from the left cleaning box into the container.
Change of solvent (right side of the unit):
Remove the Front cover.
Pull the suctionhose out of the left can inside the body of the unit. Refill it with solvent (Ref chapter "Permitted solvent" above).
Put the can back on the left shelf and insert the suction hose all the way down.
Empty the right can for return solvent (placed inside the body of the unit) into a suitable waste drum for hazardous waste, or into a
solvent recycler for reuse.
Put the can back on the right shelf so that the drain hose from the right cleaning box runs into the hole of the can.
Refit the Front Cover.
Other:
Replace the brush in the cleaning box on either side whenever needed.
In order to maintain the high safety standard of the unit, you should ensure the following:
- that the unit is installed in the manner prescribed in this manual
- that the unit is used in the manner prescribed in this manual
- that the unit is maintained in the manner prescribed in this manual
- that only original spare parts are used
- that this manual is kept available and in legible conditions close to the unit.
Hedson Technologies AB will replace all faulty parts on the DRESTER Quick Rinse QR-TT with new parts in accordance with
the "Warranty Terms for Hedson Technologies AB No. 7.2-8". This warranty only remains valid if the machine is used in the
prescribed manner, and it does not cover the cost of repairs. Always state the machine's serial number and year of manufacture if
making a claim under warranty. These can be found on the machine's silver-coloured rating plate. The warranty terms may vary
from country to country. The importer can provide you with details.
Manufacturer
Type of machine:
Permitted solvents:
Liquid volume of machine:
Compressed air needed:
Pump capacity:
Weight
Overall dimensions:
Sound pressure level:
INSTR: 15117
OPERATING INSTRUCTIONS

SAFETY INFORMATION

WARRANTY

TECHNICAL DATA

HEDSON TECHNOLOGIES AB
Hammarvägen 4
SE-232 37 Arlöv
Sweden
Tel.: +46-40- 53 42 00
DRESTER Quick Rinse QR-TT
See section "Permitted Solvents"
3 litres of solvent, amount of water depending on chosen size of container
5-12 bar (80-180 psi), 100 l/min (4 cfm)
2 l/min
16 kg (32 lb)
See illustration below
<70 dB(A)
REV: 2/ 090529 / Bom
SERVICE
GODK:
Patent pending
SID: 3 / 20