3M PELTOR TEP-100 Instrucciones De Uso página 6

Attaching Eartips and Optional Retention Cord
Use only 3M™ PELTOR™ Eartips designed for use with this product. Do not insert the
earpiece (Fig. A:4) directly into the ear without a correctly attached 3M PELTOR eartip.
1. To attach the optional retention cord, place one end of the retention cord onto the
eartip stem (Fig. A:4 and Fig. E:1).
2. Push eartips (Fig. A:5) onto the eartip stem (Fig. A:4 and Fig. E:2).
3. Fully seat the eartip at the base of the eartip stem (Fig. E:3).
Fig. E:1
Fitting 3M PELTOR Tactical Earplug, TEP-100
The earpiece should be powered off prior to insertion. Eartips should be clean and in good
condition before fitting.
1. Select a proper eartip size for your ear canal.
2. Hold the tactical earplug with the eartip attached (Fig.F:1).
3. Insert rounded eartip into ear canal while pulling the ear outward away from the head
and upward with the opposite hand (Fig.F:2).
4. Rotate the tactical earplug toward the back of the head (Fig.F:3).
5. With the tactical earplug powered off, check to ensure you have a good eartip fit.
Pull the earpiece gently. It should not come out of ear easily. If it does, repeating insertion.
Listen to steady loud noise with eartips in both ears. The noise should sound softer.
Cover ears with tightly cupped hands. Noise should sound about the same whether or not
ears are covered. If you cannot obtain a good fit, try a different type or size of eartip.
CAUTION! For greater comfort and safety when using the three-flange 3M UltraFit Eartips,
remove the eartip slowly with twisting motion to gradually break the seal.
Fig. F:1
Fig. E:2
Fig. F:2
6
Fig. E:3
Fig. F:3