Steelcase Ology Instrucciones De Uso página 16

_______________________________________________________________
1 Control panel
2 Toggle switch "up"
Toggle switch "down"
3
ATTENTION
Risk of damage to control panel!
Do not lean on the operating

panel.
 Do not place any objects on the
operating panel.
 Do not pour liquids over the
operating panel.
Simple Touch
Manual reset on
An end position calibration of the lowest desktop
position must be performed:
■ Prior to placing the desk in service
■ When the actual desktop position no longer
matches the displayed desktop position.
■ When a previously configured motor controller is
used in a different electrically height adjustable
workstation of the same design.
 Press the operating panel down-
wards and hold it down until it
reaches the lower end position.
 Release the operating panel for 1
second.
 Press the operating panel down
again and hold down for approx. 5
sec.
 The desktop moves to the lower end
position and makes a short move-
ment.
 Release the operating panel. The
system is now ready for operation.
14
operating panel
Operating and adjusting
If the operating panel is released before
the process is complete, the manual reset
process will be interrupted and must be
restarted.
Adjusting the desk height with
operating panel
Before performing the height adjustment, you must
ensure that:
■ No one is in the lifting range. No objects (such as
open doors or windows) are in or protrude into
the lifting range.
■ There are no objects in the lift range of the lift
column.
■ No one is on the desk.
■ The maximum permissible load-carrying capacity
of the desk is not exceeded (see
data
).
■ No heavy loads are on the desktop. Heavy loads
make the height adjustment more difficult.
The desktop is level. If the floor is uneven, align the
desktop with the adjusting screws on the feet.
Ensure that the connecting cables of
devices on the desk are long enough.
 Press the operating panel downwards
until the lower end position (pro-
grammed desktop position) is reached.
A lift movement takes place only:
■ As long as the corresponding operating panel is
pressed.
■ As long as the maximum load (approx. 75 kg) is
not exceeded.
ATTENTION
Risk of damage to the desktop!
If desktop movement occurs on
one side only or unevenly:
 Release the operating panel
immediately to stop the
movement.
Simple Touch
3.1 Technical
120917