Steelcase Ology Instrucciones De Uso página 18

_______________________________________________________________
 Press the operating panel (tog-
gle switch) "up" or "down".
A lift movement takes place only:
• As long as the corresponding operating panel is
pressed.
• As long as the maximum load (approx. 75 kg) is
not exceeded.
• If a pre-programmed height (MEM1 or MEM2)
is reached, the system stops briefly (500ms) and
then continues as long as the operating panel is
pressed.
The desk moves at a speed of approx.
4 cm/s.
ATTENTION
Risk of damage to the desktop!
If desktop movement occurs on one side only
or unevenly:
 Release the operating panel
immediately to stop the
movement.
 Determine the cause using the
fault-finding table (see
and malfunctions
AutoRun operation
With this panel, the desk reaches the
stored height without having to touch the
controls permanently.
 Tap the control panel twice in the
direction you want the desktop to
move.
 The desktop moves up or down
automatically to the stored desk
position.
 To stop the automatic movement,
tap the control panel.
16
6 Faults
).
Operating and adjusting
Start indication in the display
If the system is supplied with power, the Steelcase
logo appears for a few seconds when the power is
switched on and disappears again.
Height indication in the display
The desk height is displayed whenever the system is
moved. The increments are displayed in whole
centimetres when the centimetre setting is selected.
In inch (INCH) mode with one decimal place and
increments in 0.1 increments.
Switching the display between centimetres
and inches
A selection can be made to have the height displayed
in centimetres [cm] or inches [inch]. This selection
does not affect the actual height of the desk.
To change the unit displayed, proceed according to
the information in the table below:
 Press the position memory
 The display switches from
Resetting to factory settings
 Press the position
 The system resets to the
Setting the memory position
This function is used to save a specific desktop
height. Each position memory button (1, 2) can store
button MEM1 and the
REM button at the same
time
CM to INCH and back
memory buttons MEM1,
MEM2 and the REM but-
ton at the same time
factory settings.
120917