Active Touch Operating Panel - Steelcase Ology Instrucciones De Uso

_______________________________________________________________
ATTENTION
Determine the cause using the

fault-finding table (see Error
messages on the display of the

Active Touch operating panel).

Consult a service technician if

necessary.
Active Touch
5.2.6
The Active Touch operating panel allows the storing
of two positions.
5 Operating and adjusting
to set the memory positions.
Figure 5-4: Operating panel Active Touch variant
1 Toggle switch "down"
2 Toggle switch "up"
3 Display
4 Button "1" (MEM1 – memory position 1)
5 Button "2" (MEM2 – memory position 2)
6
Button = "REMINDER" interval
Active Touch
Manual reset on
An end position calibration of the lowest desktop
position must be performed:
■ Prior to placing the desk in service
When the actual desktop position no longer
matches the displayed desktop position.
 Press the operating panel down-
wards and hold it down until it
reaches the lower end position.
120917
operating panel
describes how
operating panel
Operating and adjusting
 Release the operating panel for 1
second.
 Press the operating panel down
again and hold down for approx. 5
sec.
 The desktop moves to the lower end
position and makes a short move-
ment.
 Release the operating panel. The
system is now ready for operation.
If the button is released before the
process is completely concluded, the
manual reset process will be interrupted
and must be restarted.
Adjusting the desk height with
operating panel
Before performing the height adjustment, you must
ensure that:
■ The display of the operating panel does not show
an error message (see
malfunctions
).
■ No one is in the lifting range. No objects (such as
open doors or windows) are in or protrude into
the lifting range.
■ There are no objects in the lift range of the lift
column.
■ No one is on the desk.
■ The maximum permissible desk load-carrying
capacity is not exceeded (75kg).
■ No heavy loads are on the desktop. Heavy loads
make the height adjustment more difficult.
■ The desktop is level. If the floor is uneven, align
the desktop with the adjusting screws on the
feet.
Ensure that the connecting cables of all
devices on the desk are long enough.
Active Touch
6 Faults and
15