Installing The Desk; Manufacturer; Height Levelling - Steelcase Ology Instrucciones De Uso

_______________________________________________________________
The plug of the desk must be easily
accessible at all times.
Figure 4-2: Electrical connections
Information on the connections for the
motor controller can also be found under:
http://www.linak.de/deskline/?id3=2396
DL12, DL14, DB14, DL17

4.7 Installing the desk

Setup and use of the product requires detailed
planning. For this Steelcase offers the services of a
separate planning department.
The partially-assembled units for the Ology desk are
generally supplied via retailers or directly from the

manufacturer.

The installation location must meet the following
requirements:
■ Sufficient carrying capacity of the floor
■ Level placement surface
■ Temperature range: +5 °C to +40 °C.
■ Max. rel. humidity: 80 %

4.8 Height levelling

To compensate for uneven ground, you can raise
each foot by up to 1.0 cm with an adjusting screw.
For a desk that has already been assembled: before
levelling, remove any objects from the desktop.
120917
Figure 4-3: Ology height compensation
1 Adjusting screw
>
Figure 4-4: Ology Bench height compensation
1 Adjusting screw
 Remove all objects from the desk.
 Turn the adjusting screw until height compensa-
tion is complete.
Transport and storage
11