Charging The Battery - Hilti XBT 4000-A Manual De Instrucciones

spring back to its original position so that sustained
operation is ended.
7.5 Belt hook
This can be used to hang the drill from a belt in a posi-
tion close to the body. The hook's ideal position is 30°
above the horizontal.
1. Remove the battery.
2. Press the button I.
3. Lift the belt hook until it engages 30° above the hor-
izontal II.
Left-handed users can fit the belt hook on the other side
of the drill.
1. Press the button I.
2. Lower the belt hook 70° below the horizontal I.
3. Pull the belt hook out of its guide.
4. Push the belt hook into the guide on the other side of
the drill II. For this purpose, the scaffold hook must
lie against the battery, so that the guide slots in the
motor housing and scaffold hook are vertically aligned
to allow the pins to be secured III.
5. Lift the belt hook again until it engages in the hori-
zontal position III.
-NOTE-
Make sure that the belt hook is securely fixed.
7.6 Scaffold hook
This hook provides a convenient means of temporarily
hanging the drill from neighbouring scaffolding, e.g. to
free the hands for other tasks. It can be completely
removed if not required.
7.6.1 Removing the scaffold hook
1. Remove the battery.
2. Press the button I.
3. Lower the belt hook 70° below the horizontal II.
4. Pull the belt hook out of its guide III.
5. Remove the scaffold hook III.
6. Push the belt hook into the guide III.
7. Lift the belt hook again until it engages in the hori-
zontal position II.
7.6.2 Fitting the scaffold hook
1. Press the button I.
2. Lower the belt hook 70° below the horizontal II.
3. Pull the belt hook out of its guide III.
4. Fit the scaffold hook. For this purpose the scaffold
hook must lie against the battery, so that the guide
slots in the motor housing and scaffold hook are ver-
tically aligned to allow the pins to be secured.
5. Push the belt hook into the guide III.
6. Lift the belt hook again until it engages in the hori-
zontal position II.
7. Push the battery into the tool.
-NOTE-
Check that the scaffold hook is securely engaged.
Use the scaffold hook only for as long as necessary.
Printed: 08.07.2013 | Doc-Nr: PUB / 5071408 / 000 / 01
Lay the tool down in a secure position when it is no
longer in use.
7.7 Removing the battery (2-fingered operation)
1. Press both release buttons.
2. Pull the battery downwards out of the drill.
7.8 Inserting the battery
Use the Hilti SFB 185 battery only.
1. Push the battery into the drill from below until heard
to engage.

7.9 Charging the battery

Use only the Hilti, C7/24, C7/36-ACS, SFC 7/18H, SFC
7/18 or TCU 7/36 charger.
Incorrect use may lead to electric shocks, overheating
of the battery or leakage of a caustic liquid from the bat-
tery.
Read the operating instructions for the charger before
beginning charging.
en
17