Mounting The Pressure Rollers En - Abicor Binzel MF1-Rear Instructivo De Servicio

MF1-Rear
1 2
12
11
10 9
1
Eccentric bolt
2 Drive gears (2 pcs.)
3 Knurled screws (2 pcs.)
4 Feeder drive rollers (2 pcs.)
Fig. 2 Mounting the feed rollers
6.1.1 Mounting the pressure rollers
1 Lift off the cover (5).
2 Press on the rocker (10) then rotate the eccentric bolt (1) and remove it upwards.
3 Unscrew the knurled screw (6) and lift off the rocker (10).
4 Loosen the knurled screws (7) and press out the axle (9) downward.
5 Remove the drive gears (11).
6 Place the feed rollers (12) on the drive gears (11).
7 Insert the drive gears (11) and axles (9) and secure in place using knurled screws (7).
8 Place the rocker (10) on the bolt and secure with the knurled screw (6).
9 Swivel the rocker (10) into position, insert the eccentric bolt (1) and turn it over.
10Put on the cover (5).
BAL.0410.0 • 2018-08-15
3
8
5
Cover
6 Knurled screw
7 Knurled screws (2 pcs.)
4
7 6
8
Pressure screw
9 Axles (2 pcs.)
10 Rocker
6 Commissioning
5
11 Drive gears (2 pcs.)
12 Feeder pressure rollers (2 pcs.)
EN - 9