Slave Mode; Device Settings - Cameo LED TS 40 WW Manual De Usuario

SETTING THE DMX MODE
Pressing MENU will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "Mode" (lower line) and
confirm with ENTER. Now use the UP and DOWN buttons once more to select the "DMX" sub-menu item and confirm by pressing ENTER.
Using UP and DOWN, select the desired DMX mode (1CH, 3CH, 5CH) and confirm with ENTER. Press MENU twice to return to the main
display. The main display is automatically activated if no input is made within about 30 seconds. You will find tables with the channels of the
different DMX modes in this manual under DMX CONTROL.
SELECTING THE DMX START ADDRESS
Pressing MENU will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "DMX Addr" and confirm
with ENTER. Now you can select the DMX start address as desired by using the UP and DOWN buttons. Confirm with ENTER and press
MENU once to return to the main display. The main display is automatically activated if no input is made within about 30 seconds.
STATIC MODE
Pressing MENU will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "Static" and confirm
by pressing ENTER twice. Now you can select the brightness of the spotlight as desired with values ranging from 000 (Blackout) to 255
(maximum brightness) by using the UP and DOWN buttons. Confirm with ENTER and press MENU once more to return to the main display.
The main display is automatically activated if no input is made within about 30 seconds.

SLAVE MODE

Pressing MENU will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "Mode" (lower line) and
confirm with ENTER. Now use the UP and DOWN buttons once more to select the "Slave" sub-menu item and confirm by pressing ENTER.
Connect the slave and the master unit (same model) with a DMX cable and activate the Static standalone mode on the master unit. Now the
slave unit follows the master unit. Press MENU once more to return to the main display. The main display is automatically activated if no
input is made within about 30 seconds.

DEVICE SETTINGS

Pressing MENU will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "Settings" and confirm
with ENTER. You will then be taken to the sub-menu to set the sub-menu items (see table). Press MENU once more to return to the main
display. The main display is automatically activated if no input is made within about 30 seconds.
7