Slave Mode - Cameo ROOT PAR TW Manual De Usuario

This will take you to the submenu for setting the submenu options (see table, use UP and DOWN
to select, press ENTER to confirm, use UP and DOWN to change status/value, press ENTER to
confirm). The settings remain unchanged even once the device is restarted.
LOOP MODE
Dimmer Adjusts the brightness
Steptime Adjusts the step time
Fadetime Adjusts the fade time in percent
Sound Deactivates (Off) or activates (On) music control
Sens Microphone sensitivity for music control
Delay Delay time for slave groups
1st step 4 presets with various color temperatures
2nd step 4 presets with various color temperatures plus blackout

SLAVE MODE

Standard Slave mode: Starting from the main display, press MODE to go to the main menu.
Using UP and DOWN, now select the Slave menu option, press ENTER to confirm, then select
Slave Group 0, and select ENTER once again to confirm. Connect the slave and master unit (same
model, same software version) using a DMX cable, and activate one of the stand-alone modes
(Direct, CCT, Loop) on the master unit. The slave unit will now follow the master unit precisely.
Advanced slave mode: In the advanced master/slave mode, the control signal can be repro-
duced with a time delay of up to 15 levels. The delay time is set on the master unit in the Delay
submenu option in the stand-alone mode Loop and the delay factor for the corresponding slave
14
Main display
0–100
0.1 sec. to 10.0
sec.
0%–100%
Off/On
0–100
0.0 sec. to 2.0
sec.
Hal (Halogen)
Neu (Neutral)
Stu (Studio)
Day (Daylight)
Hal (Halogen)
Neu (Neutral)
Stu (Studio)
Day (Daylight)
Black (Blackout)