Test Mode And Software Updates; Straight Line Test; Software Updates - Bosch BCR1 Serie Instrucciones De Uso

Test mode and software updates

Straight line test

For measuring dust collection performance in accordance with IEC 62885-7, testers
can activate the "Straight line" programme by pressing and holding the "MAP" button
for at least 5 seconds and then starting it via the app. Please note the that battery
must be sufficiently charged. To deactivate this programme, switch the appliance off
and on again using the on/off switch.

Software updates

We work continuously on improving our products. To benefit from these improve-
ments, you can update the software on the appliance.
Information
To receive software updates on your robot vacuum, connection to the Home Connect
server (backend connection) must be activated in the app. This is set to active by
default.
For security reasons, updates can only be carried out if your mobile device is connec-
ted to the same network as the robot vacuum.
The app will notify you when an update is available. Confirmation is required to down-
load the update.
Once the update has downloaded, the app will prompt you to confirm installation.
You will then receive confirmation that the software update has been successful.
!
Caution
Updates can only be downloaded and installed when the robot vacuum is on the
charging station.
Do not switch off the robot vacuum during this time.
If you use the appliance, the download is interrupted.
The appliance cannot be used during installation.
112
en