Tabla de contenido
Publicidad
SECTION
Ill. STRAIGHT
STITCH
SEWING
Straight
Stitch
(&) Stitch selector:
4 to 6
® Stitch width:
6.5
(_) Stitch length:
Red zone
(_ Needle thread tension:
2 to 6
(_) Presser foot A:
Zigzag foot
_) Presser foot H:
Straight stitch foot
NOTE:
There are three straight stitch needle position settings,
left, center and righL When using the straight stitch foot,
make sure to use center needle position Otherwise the
needle may strike the sewing foot and possibly break.
Starting to sew
Raise the presser foot and position the fabric next to a
seam guide line on the needle plate (5/8" (1 6 cm) is most
common)
Lower the needle to the point where you want
to start. Lower the presser foot and pull the threads
toward the back. Depress the foot control
Gently guide
the fabric along a seam guide line letting the fabric feed
naturally.
CAUTION: Do not place fingers near to the presser foot
when guiding fabric, or the needle clamp screw may
strike and injure your fingers
Finishing
sewing
To fasten the ends of a seam, press the reverse stitch
control and sew several reverse stitches. Raise the
presser foot
Remove the fabric, draw the threads to the
back and cut them with the thread cutter. The threads are
now the proper length to begin sewing the next seam.
Use the Seam
Guides
(_ Center needle position
® Edge of fabric
(_) Needle plate guide lines
The seam guides on the needle plate are there to help you
measure seam width. The numbers on the needle plate
indicate the distance between the center needle position
and the edge of the fabric. The lines are 1/8" (0.3 cm) apart,
and are engraved at 3/8", 4/8", 5/8", and 6/8'L The lines in
millimeters are 5 mm apart, and are engraved at 10 mm, 15
mm and 20 mm
Turn a Square Corner
C) Cornering guide
When sewing with fabric edge at 5/8" seam guide, to turn a
square so that sewing continues at same distance from edge,
1, Stop stitching when front edge of fabric reaches the
cornering guide lines
2, Lower the needle by turning the hand wheel
countemlockwise
3 Raise the presser foot and turn the fabric
counterclockwise
90 °
4. Lower the presser foot, and begin stitching in the new
direction
f
f
f
®
I
I
I
I
I
I
_T_lq
LI_I_Gnl
e --o_1_=--=_4
®
®
®
%Or ouO
\
J
J
J
J
38
Publicidad
Tabla de contenido
