SEVERIN TO 9720 Instrucciones De Uso página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
∙ Caution: Do not place aluminium foil or
anything similar between the grill rack and
the pizza stone. Place the stone directly
onto the rack.
∙ Do not allow the power cord to touch any
hot parts of the appliance.
∙ Do not let the power cord hang free.
∙ Always switch off and remove the plug
from the wall socket
- after use, as well as
- in cases of malfunction, and
- during cleaning.
∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
∙ This appliance is intended for domestic or
similar applications, such as
- in shops, offi ces and other similar
working environments,
- in agricultural working environments,
- by customers in hotels, motels etc. and
similar establishments,
- in bed-and breakfast type environments.
Temperature control
With the temperature control knob, the
temperature can be set to the desired level.
4-position switch settings
Upper heat with hot-air convection
Upper heat
Lower heat
Upper heat and lower heat with hot-air
convection
The heating elements will only be switched
on after the timer is activated.
12
Timer
The timer can be used for selecting either
a certain cooking time (up to 60 minutes) or
continuous operation.
For continuous operation, turn the timer knob
anti-clockwise to the position
appliance off, turn the timer knob back to
position '
'.
To programme a time, turn the timer knob
clockwise to the desired value.
To set a time of less than 10 minutes, turn
the timer to a somewhat higher setting fi rst
and then slowly turn it back to the desired
time setting. After the pre-programmed time
has elapsed, an acoustic signal indicates
that the heating elements are switched off.
Indicator lamp
The indicator lamp lights up when the
appliance is switched on. It goes out once
the pre-programmed time has elapsed, or if
the switch is turned back to position
Pizza stone
∙ Always place the pizza stone on the
middle of the grill rack before inserting the
rack into the appliance.
∙ Preheat the appliance to the required
temperature as described in the section
Operation.
∙ With certain pre-baked pizzas made from
especially light dough, the pre-heating
phase should be shortened; this is to
prevent the bottom layer of the pizza
dough from browning too fast.
∙ After pre-heating, open the door and use
a spatula to place the pizza on the centre
of the stone. The pizza should be slightly
smaller than the stone so that there is a
clear space all round it.
∙ The pizza is ready once the cheese
. To turn the
.

Publicidad

Tabla de contenido
loading

Tabla de contenido