Assembling The Blower; Connecting Charger To Power Supply - Stihl BGA 100 Manual De Instrucciones

Assembling the Blower

Nozzle
WARNING
To reduce the risk of injury, operate the
unit only with a properly mounted
nozzle.
Mounting the Nozzle
3
1
2
Push the nozzle (1) onto the blower
N
tube (2) as far as mark that suits
your height.
Rotate the nozzle (1) in the direction
N
of the arrow and engage it in the
slot (3).
Adjusting the Nozzle
Rotate the nozzle (1) clockwise as
N
far as the stop.
Slide the nozzle (1) to the
N
appropriate mark on the blower
tube (2) that suits your height.
Rotate the nozzle (1) in the direction
N
of the arrow and engage it in the
slot (3).
BGA 100
Removing the Nozzle
Rotate the nozzle (1) clockwise as
N
far as the stop.
Pull the nozzle (1) off the blower
N
tube (2).
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
English
2
1
11