Stihl BGA 100 Manual De Instrucciones página 9

Do not use the power supply cord for
any other purpose, e.g. for carrying or
hanging up the charger.
Never use power supply cords that do
not comply with regulations.
Make sure the power supply cord is
located and/or marked so that it will not
be stepped on, tripped over, come in
contact with sharp edges or moving
parts or otherwise be subjected to
damage or stress.
An extension cord should not be used
unless absolutely necessary. If an
extension cord must be used, plug the
charger into a properly wired 16 gauge
(AWG 16) or heavier gauge extension
cord with blades that are the same
number, size and shapes as the blades
on the charger.
WARNING
To reduce the risk of electric shock:
Always connect the unit to a
–
properly installed wall outlet.
Make sure the insulation of the
–
power supply cord and plug is in
good condition.
Unplug the power supply cord from the
outlet when charger is not in use.
Never store a battery in the charger.
Read, fully understand and observe the
instruction manual for the STIHL charger
and keep it in a safe place.
BGA 100
THE USE OF THE POWER TOOL
Transporting the Unit
WARNING
Always switch off the power tool, move
retaining latch to ƒ and remove the
connecting cord – even when you
transport the unit for short distances.
Carry the machine by the control handle.
When transporting it in a vehicle,
properly secure the power tool to
prevent turnover and damage.
Remove the connecting
cord from the power tool.
This avoids the risk of the
motor starting
unintentionally.
Before Starting Work
WARNING
Always check your power tool for proper
condition and operation before starting,
particularly the trigger switch and
retaining latch. The trigger switch must
move freely and always spring back
when the retaining latch is on ‚. When
the retaining latch is on ƒ, it should not
be possible to depress the trigger
switch. Never attempt to modify the
controls or safety devices.
WARNING
Never operate your power tool if it is
damaged, improperly adjusted or
maintained, or not completely or
securely assembled.
WARNING
A worn impeller housing (cracks, nicks,
chips) may result in an increased risk of
injury from thrown foreign objects. If the
impeller housing is damaged, consult
your dealer. STIHL recommends you
contact a STIHL servicing dealer.
Keep the handle clean and dry at all
times; it is particularly important to keep
it free of moisture, pitch, oil, grease or
resin in order for you to maintain a firm
grip and properly control your power
tool.
Check contacts in the socket for foreign
matter. Keep clean.
Fit the plug of the connecting cord
correctly.
For starting, see chapter on "Switching
On".
WARNING
Your power tool is a one-person
machine. Do not allow other persons in
the general work area, even when
starting.
During Operation
Holding and Controlling the Power Tool
WARNING
To reduce the risk of injury from loss of
control, never work on a ladder, in a tree
or any other insecure support. Never
hold the machine above shoulder
height.
English
7