To use the player before a timer
playback starts
Just turn on the player, and then you can use
it.
If you turn off the player before the preset
time, timer playback will start at the preset
time.
In case of the radio, however, if you listen to
the station which is different from the one
you tuned in step 1 on page 20, you will hear
that station at the preset time. Make sure to
tune in the station you want to listen to
before you turn off the player.
To stop play
Press OPERATE (or POWER) to turn off
the power.
Notes
• When you press STANDBY in step 7 on page
20, make sure that n or z button of the tape
player is not pressed.
• When you press n or z button of the tape
player in the timer mode:
If the tape length of one side is longer than the
set time, the player will be turned off at the end
of the tape, not at the set time.
Tips
• To exit the standby mode, press STANDBY to
make
disappear from the display.
• The preset settings remain until you reset them.
Falling asleep to music
You can set the player to turn off
automatically after 10, 20, 30, 60, 90, and
120 minutes, allowing you to fall asleep
while listening to music.
CLOCK/SLEEP/TIMER
ENTER
1
Play the music source you want.
2
Press CLOCK/SLEEP/TIMER until
"SLEEP" appears in the display, and
press ENTER.
3
Turn the jog dial to select the minutes
until the player goes off automatically.
Each time you turn the jog dial, the
indication changes as follows:
"60" t "90" t "120" t "OFF" t
"10" t "20" t "30."
Jog dial
continued
GB
21