Sony CFD-E90 Manual De Instrucciones página 24

Choosing the power sources
(continued)
2
Connecting the mains lead
Insert one end of the supplied mains
lead to the AC IN socket located at the
rear of the player, and the other end to
the mains.
Changing the AM/MW tuning
interval
The AM/MW tuning interval is preset to
9 kHz at the factory.
If you need to change the AM/MW tuning
interval, do the following:
1 Press RADIO•BAND•AUTO PRESET
until "AM" or "MW" is displayed.
2 Press ENTER for 2 seconds.
3 Press RADIO•BAND•AUTO PRESET for
2 seconds.
"AM 9" "MW 9" or "AM 10" "MW 10"
flashes.
4 Turn the jog dial to select "AM 9"
"MW 9" for 9 kHz interval or "AM 10"
"MW 10" for 10 kHz interval.
5 Press ENTER.
After changing the tuning interval, you need
to reset your preset AM/MW radio stations.
3
Inserting batteries into the remote
Insert two R03 (size AAA) batteries
(not supplied).
Replacing batteries
With normal use, the batteries should last for
about six months. When the remote no
longer operates the player, replace all the
batteries with new ones.
GB
24
4
Using the player on batteries
Insert six R14 (size C) batteries (not
supplied) into the battery compartment.
To use the player on batteries,
disconnect the mains lead from the
player.
Replacing batteries
Replace the batteries when the OPR/BATT
indicator dims or when the player stops
operating. Replace all the batteries with new
ones.
Notes
• Before you replace the batteries, be sure to take
out the CD from the player.
• When you operate the player on the batteries,
you cannot turn on the player with remote.
Tip
When you operate the player on batteries, replace
the back-up batteries when the time display dims
or when you cannot operate the timer. Replace all
the batteries with new ones. With normal use, the
back-up batteries should last for about six months.
To save the memory data, replace the batteries
with the mains lead connected.