Surtek 107369 Manual De Usuario Y Garantía página 12

E N G L I S H
THE OPPOSITE CYLINDER IS ALWAYS OPPOSITE
NO. 1 CYLINDER ON DISTRIBUTOR CAP
ROTARY ENGINE
The Timing Light can be used on Rotary engines.
Follow the manufacturer's specific instructions
and specifications. Below is a typical procedure
for the Mazda twin rotor engine.
1. Connect the Red and Black power leads clamps
to the battery. Connect wire with the spark plug
adaptor to the leading spark plug on the front
rotor housing.
2. Start the engine and run at idle speed.
3. Aim the timing light at the timing indicator
pin or the front cover.
4. Loosen the distributor locking nuts and rotate
the leading side distributor body until the timing
mark on the eccentric shaft pulley are in line
with the timing, indicator pin.
5. Tighten the locking nuts and recheck the
timing.
6. Repeat the above step for setting the trailing
side distributor timing with the timing light
connected te the trailing spark plug.
12
FIGURE 8.
XENON LAMP REPLACEMENT
If procedures outlined in above do not correct
the failure, the most probable cause is a
defective Xenon lamp.
The lamp may have a black spot around the
anode, this is perfectly normal. However, if the
lamp is completely black it has reached its end of
life and should be replaced.
See Figure 9.
FIGURE 9.