Vermeiren Albatros II Manual De Instrucciones página 15

2.3.5 Thorax support
2.3.6 Raising and lowering the cantilever arm
The manual control allow the cantilever arm to be adjusted
smoothly to any point.
1
2
1 2
L
Force required to activate the pushbutton: < 5N
Position the manual control to the top tube of the handles for moving the patient hoist. This is
the most ergonomic position.
To stabilize and support your thorax, the lift is
equipped with thorax pillow and velcro belts
to stabilize.
The thorax support can be adjusted in 2
different positions 1045 mm, 1200 mm.
These positions are measured from the
footplate until the top of the thorax support.
= Raise the cantilever arm
= Lower the cantilever arm
When using the lift function until the end of the hoist
motor the limit switch is activated by electronics (security
function). Use the lifting function only in the middle of the
adjustment range.
Page 13
1. Remove the safety pin
2. Adjust the thorax support in the
desired position. The position from
attachment plate
shown in figure.
3. Mount the safety pin
Albatros II
2012-09
.
shall be like
securely.