Shure GLXD4 Instrucciones De Uso página 9

Transmitters
① Antenna
Carries wireless signal.
② Status LED
LED color and state indicate transmitter status.
③ Power Switch
Turns the transmitter on/off.
④ TA4M Input Jack
Connects to a 4-Pin mini connector (TA4F) microphone or instrument
cable.
⑤ Micro USB Charging Port
Connect to USB battery charger.
⑥ Link Button
• Press and hold within 5 seconds of power-on to manually link with
receiver
• Press momentarily to activate Remote ID function
⑦ Battery Compartment
Holds 1 Shure rechargeable battery.
⑧ Microphone Cartridge
GLXD-2 transmitter models are available with the following cartridge
types: SM58, Beta 58, SM86, Beta 87A.
Transmitter Status LED
LED is green during normal operation.
LED color or flashing indicates a change in transmitter status as shown in
the following table:
Color State
Green Flashing (slow)
Flashing (fast)
Flashes 3 times
Red On
Flashing
Red/Green Flashing
Amber Flashing
Wearing the Bodypack Transmitter
Clip the transmitter to a belt or slide a guitar strap through the transmitter
clip as shown.
For best results, the belt should be pressed against the base of the clip.
Status
transmitter attempting relink with
receiver
unlinked transmitter searching for
receiver
indicates locked transmitter when pow-
er switch is pressed
battery life < 1 hour
battery life < 30 minutes
remote ID active
battery error, replace battery
4 3
1
off on
7
Wearing the Headworn Microphone
• Position the headworn microphone 13 mm (1/2 in.) from the corner of
your mouth.
• Position lavalier and headworn microphones so that clothing, jewelry,
or other items do not bump or rub against the microphone.
Correct Microphone Placement
• Hold the microphone within 12 inches from the sound source.
• For a warmer sound with increased bass presence, move the
microphone closer to the sound source.
• Do not cover grille with hand.
2
GLXD2
on
5
6
6
7
1
13 mm
(.5 in.)
8
2
3
5
9