SEVERIN TO 2049 Instrucciones De Uso página 10

socket, never pull on the power cord;
always grip the plug itself.
●
Caution: Before changing the light bulb
in the oven compartment, ensure that the
appliance is
disconnected from the power supply.
There is otherwise a risk of electric
shock.
●
No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
●
This appliance is intended for domestic
use only and not for commercial
applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Temperature control
With the temperature control knob, the
temperature can be set to the desired level.
5-position switch settings
●
(large dot symbol) – both hot-plates
enabled
(small dot symbol) small hot-plate
●
enabled
Upper heating elementand small hot-
plate enabled
Lower heating elementand small hot-
plate enabled
Both upper and lower heating elements
and small hot-plate enabled
Before using for the first time
- Clean the appliance (see General care
and cleaning) and remove any packing
materials completely.
- Before using the appliance for the first
time, let the interior heat up for 10
minutes with both heating elements on.
A slight smell may be emitted; this is
switched off and
normal and will only last for a very short
time. Ensure sufficient ventilation.
- Before using the hot-plates for the first
time, let them heat up for approximately
3 minutes at maximum power, while
ensuring sufficient ventilation. This will
help to 'burn in' the protective coating
which safeguards the hot-plates against
corrosion. During this process, a slight
smell and a little smoke may be emitted.
This is normal and will only last for a very
short time.
Using the oven compartment
- Pre-heat the oven compartment for
several minutes with the door closed,
using both heating elements. Set the
temperature control knob to the required
level.
- With one or both heating elements
switched on, the compartment is
illuminated by the interior lamp.
- Place the food to be cooked on the
baking rack. When cooking food
containing fat or moisture, use the baking
tray to stop any dripping into the interior
of the appliance.
- Close the door and set the temperature
control knob to the required level.
- For overhead baking or grilling, either
the upper or the upper and lower
elements may be selected.
- The switch settings (upper heat/lower
heat) may be changed during the cooking
process.
- To interrupt the cooking process
temporarily, set the 5-position switch to
the ' ' position (small dot symbol).
●
- Always use the door handle to open the
hot door after use. When removing the
baking tray, use the tray handle provided.
To remove the baking rack, an oven
cloth must be used. Always place the
baking tray on a heat-resistant surface.
- After use, set the 5-position switch to the
' ' position (small dot symbol) and
●
remove the plug from the wall
6
socket.