SEVERIN TO 2049 Instrucciones De Uso página 11

Using the hot-plates
- Always place a pot / saucepan on the hot-
plate and set the 5-position switch to the
'●' position (large dot symbol) before
switching on.
- With one or both hot-plates switched on,
the indicator lamp is lit.
- Ensure that the pot is clean and dry on
the outside. Do not use stain covered or
soot pots / saucepans.
- To prevent damage to the hot-plate, only
use pots / saucepans with flat bottoms.
Most suitable are pots specifically
designed for use on electric plates (see
picture I).
- Always make sure that the pot /
saucepan used is of at least the same
diameter as the plate; this minimises the
loss of heat and prevents the plate from
being damaged as a result of uneven heat
distribution.
- After use, set the 5-position switch to the
' ● ' position (small dot symbol) and
remove the plug from the wall
Thermostat settings
3: Pre-cooking and quick frying
2: Regular cooking, frying
1: Simmering
Always set the temperature control knob to
position '0' after use.
General care and cleaning
●
Before cleaning the appliance, ensure it is
disconnected from the power supply and
has completely cooled down.
●
To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
●
Do not use abrasives, harsh cleaning
solutions or spray-type oven cleaners.
- The exterior housing and the door may
be cleaned with a damp, lint-free cloth.
- To clean the stainless steel areas, only a
mild, non-abrasive cleaning agent
intended for such sensitive surfaces may
be used.
●
Do not clean the stainless-steel surfaces
using rough or hard sponges, or those
that still contain residue from abrasive
cleaning agents.
- The baking tray, rack and crumb tray
may be cleaned using hot water and a
mild detergent, or in a dish-washer.
- After use, a wet cloth may be used to
remove any spills from the plates.
- Following a longer period of use, a
special commercially available cleaning
agent should be used to treat the plates.
Changing
compartment
The bulb is located at the rear of the right-
hand side panel behind a glass plate.
- Loosen the upper screw on the glass
plate.
- Remove the glass plate.
- Remove the bulb from its socket by
turning it anti-clockwise.
- Replace it with a new 15W bulb (socket-
type E14).
socket. - Fit the new bulb into the socket by
turning it clockwise.
- Replace the glass plate and secure it with
the screw.
Disposal
Guarantee
This product is guaranteed against defects in
materials and workmanship for a period of
two years from the date of purchase. Under
this guarantee the manufacturer undertakes
to repair or replace any parts found to be
defective, providing the product is returned
to one of our authorised service centres. This
guarantee is only valid if the appliance has
been used in accordance with the
instructions, and provided that it has not
been modified, repaired or interfered with
by any unauthorised person, or damaged
through misuse.
7
the bulb inside the oven
Do not dispose of old or defective
appliances in domestic garbage,
but only through public collection
points.