Led Display; Control Buttons - Cameo CLFLOWERHP Manual De Usuario

CONNECTIONS, CONTROLS AND INDICATORS:

LED DISPLAY

1
The four digit LED display indicates the operating mode and other system information.

CONTROL BUTTONS

2
MODE: Selecting the different operating modes.
ENTER: Confirming program selection and value changes.
UP and DOWN: Selecting a program, changing the program speed and DMX address.
DMX IN
3
3-pin male XLR socket for connection of a DMX controller (e.g., DMX mixer).
DMX OUT
4
3-pin XLR socket for looping through the DMX control signal.
POWER IN
5
IEC power socket with built-in fuse holder. Connection via the included IEC power cord.
IMPORTANT INFORMATION: Replace the fuse only with a fuse of the same type and rating. If the fuse blows
repeatedly, please contact an authorised service centre.
POWER OUT
6
IEC mains output socket. Used to supply power to additional CAMEO projectors. Make sure that the total cur-
rent consumption in amperes (A) of all connected devices does not exceed the specified value on the device.
8