Installing/ Removing The Battery Pack; Installing The Belt Clip - Kenwood TK-2402 Manual De Instrucciones

INSTALLING/ REMOVING THE BATTERY PACK

Do not short the battery terminals or dispose of the battery by fire.
◆
Never attempt to remove the casing from the battery pack.
◆

INSTALLING THE BELT CLIP

Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver. Acrylic
ester, which is contained in these glues, may crack the transceiver's
back panel.
1 Align the battery pack with the back
of the transceiver, then press the
battery pack and transceiver firmly
together until the release latch on
the base of the transceiver locks.
2 To remove the battery pack, lift
the safety catch on the base of the
transceiver, then press the release
latch underneath the safety catch.
3 While pressing the release latch,
pull the battery pack away from the
transceiver.
If necessary, attach the belt clip using
the two supplied M3 x 8 mm screws.
Note: If the belt clip is not installed, its
mounting location may get hot during
continuous transmission or when left
sitting in a hot environment.
Belt clip
3