Charging The Battery; Installation Of The Belt Clip - Kenwood UBZ-LJ9SETE Manual De Instrucciones

2.4 Charging the battery

Please fully charge the battery before use.
• Plug the USB power supply into a mains socket
and connect the USB-C charging cable to the
battery charging port on the transceiver and the
USB port on the power supply. Using the power
supply, 2 batteries can be charged at the same
time. The battery can also be charged separately
without the transceiver.
• During the charging process, the charging
indicator lights up red, indicating that the
battery is being charged. When the battery is
fully charged, the display changes to green.
Attention!
• Use only the original power supply.
• Please only charge the battery indoors.
• When the charging process is complete,
disconnect the USB cable from the battery
and the power supply from the mains socket.

2.5 Installation of the belt clip

Align the belt clip with the attachment points on the back of the transceiver and secure it with the
screws provided. Use a suitable screwdriver. Removing the battery facilitates installation.
8