Mounting Or Removing The Rear And Front Frame; Adjusting Angle Of The Steering Column - Vermeiren Venus 4 Sport Manual De Instrucciones

3.3

Mounting or removing the rear and front frame

L
WARNING: Risk of injury - Be carefull that you do not pinch your fingers, hands between
the frame.
L
CAUTION: Risk of injury - Check that the front and rear frame is fixated properly.
Removing rear frame:

1. Pull the red lever upwards.
2. Pull the front frame upwards.
3. Turn the rear frame handrips towards the ground so the electronic parts are pointed upwards.
4. The pens of the front frame has flat edges, meaning is that these edges are parallel with the hook
edges of the rear frame. Now lift the front frame upwards and you can easily take the front frame
out the rear frame.
3.4

Adjusting angle of the steering column

The steering column can be adjusted in different angles to suit each driver.
L
WARNING: Risk of injury - Never adjust the angle while you are driving.
L
WARNING: Risk of injury - Turn the scooter off before you adjust the angle of the
steering column.
L
WARNING: Risk of injury - Do not lean with your whole body on the steering column.
L
CAUTION: Risk of injury - Grasp the steering column before loosen the starknob.
Mounting frame:
1. Place the rear frame with the
electronic parts pointed
upwards. Now you see orange
marked hooks.
2. Grasp the red lever
on the front frame. On the front
frame there are orange marked
pens.
3. Mount the front
frame
mounting the orange pens in
the orange hooks.
4. Turn the rear frame towards the
front frame until it clicks into
each other.
5. Check that the front
frames
so these cannot rotate or move
anymore.
1. Loosen the starknob
2. Adjust the steering column in the desired
position.
3. Tighten the starknob
column.
Page 20
Venus 4 Sport
2015-08

located

and rear

into each other, by

and rear

are firmly secured,

.

to secure the steering