Adjusting The Rear View Mirrors; Adjusting The Armrests; Adjusting Width Armrests - Vermeiren Ceres SE Manual De Instrucciones

Headrest:
1. Gently press the locking pin
2. Move the headrest to the desired height.
3. Let go of the locking pin
4. The headrest audibly locks into place.
3.6

Adjusting the rear view mirrors

It is possible to adjust the rear view mirrors:
3.7

Adjusting the armrests

L
CAUTION
: Risk of tipping over - Make sure that the armrests are positioned
symmetrically from the seat.
L
CAUTION
: Risk of injury - Mount the inner tube always with of safe distance of 50 mm in
the outer tube.
The armrest can be adjusted in width.

toward the headrest.

.
1
Adjustment 1 (arrow A):
1. Grasp the rear view mirror .
2. Rotate the rear view mirror  in the desired position.
Or
Adjustment 2 (arrow B):
1. Move the cap  upwards.
2. Loosen the mirror screw .
3. Grasp the tube  gently.
4. Rotate the tube  and put the mirror  in the desired
position.

3.7.1 Adjusting width armrests

1. Remove the star knob
2. Grasp the inner square tube as shown in the picture.
3. Move these tube to adjust the armrest to the desired
width (range 55 mm on each side: 4 positions).
4. Retighten the star knob
5. Check that the armrest is fixated very well.
Page 23
Ceres SE
1 = Locking pin

on the back of the scooter.

.
2018-06