Filling Chain Oil Tank; Checking Chain Lubrication - Stihl MS 461 Manual De Instrucciones

Filling Chain Oil Tank

Preparing the machine
Thoroughly clean the filler cap and
N
the area around it to ensure that no
dirt falls into the tank
Always position the machine so that
N
the filler cap is facing upwards
Open the filler cap
N
Filling Chain Oil Tank
Standard oil pump
Refill the chain oil tank every time
N
you refuel
Oil pump with increased delivery rate
(available option)
Frequent checking and refilling of the oil
tank is necessary – see "Adjusting oil
quantity".
Refill the chain oil tank when the fuel
N
tank is approximately half empty
MS 461
All versions
Take care not to spill chain oil during
refilling and do not overfill the tank.
Close the filler cap
N
There must still be a small amount of
chain oil in the oil tank when the fuel tank
is empty.
If the oil tank is still partly full, the reason
may be a problem in the oil supply
system: Check chain lubrication, clean
the oil passages, contact your servicing
dealer for assistance if necessary.
STIHL recommends that maintenance
and repair work be carried out only by
authorized STIHL dealers.

Checking Chain Lubrication

The saw chain must always throw off a
small amount of oil.
Never operate your saw without chain
lubrication. If the chain runs dry, the
whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
English
29