Stihl FBD-KM Manual De Instrucciones página 7

WARNING
Always switch off the engine and make
sure the cutting blade has stopped
before putting the power tool down.
It may be carried only in a horizontal
position. Grip the shaft in a manner that
the machine is balanced horizontally.
Keep the hot muffler away from your
body and the cutting attachment behind
you.
WARNING
When transporting it in a vehicle,
properly secure it to prevent turnover,
fuel spillage and damage to the unit.
Before Starting
WARNING
Always check your power tool for proper
condition and operation before starting.
Never attempt to modify the controls or
safety devices.
WARNING
Never operate your power tool if it is
damaged, improperly adjusted or
maintained, or not completely or
securely assembled.
WARNING
Do not attach any cutting attachment to
a unit without proper installation of all
required parts. Failure to use the proper
parts may cause the blade to fly off and
seriously injure the operator or
bystanders.
FBD-KM
WARNING
The deflector and the cutting attachment
must be properly tightened and in safe
operating condition. Inspect for loose
parts (nuts, screws, etc.) and for
cracked, bent, warped or damaged
blades and parts. Replace a damaged
deflector or damaged blades before
using the power tool.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, fuel mix,
grease or resin in order for you to
maintain a firm grip and properly control
your power tool.
WARNING
To reduce the risk
of personal injury
to the operator
from blade contact
and thrown
objects, make sure
your unit is
equipped with the
proper deflector,
skirt, handle and
harness (if
applicable).
An arrow on the deflector shows the
correct direction of rotation of the cutting
blade.
The arrow on the deflector must always
face away from you, so that cuttings and
other debris will be diverted away from
the machine and your position (see
chapter "Using the Unit").
Adjust carrying harness and loop handle
to suit your size before starting work.
The machine should be properly
balanced as specified in your instruction
manual for proper control and less
fatigue in operation. To be better
prepared in case of an emergency,
practice releasing the unit from the
harness as quickly as possible.
Starting
WARNING
Start the engine at least 10 feet (3 m)
from the fueling spot, outdoors only.
For specific starting instructions, see the
appropriate section of your
KombiEngine and KombiTool manuals.
Place the power tool on firm ground or
other solid surface in an open area.
Maintain good balance and secure
footing.
English
5