Connecting Your Tv - Pioneer XW-NAS3 Manual De Instrucciones

03 iPod playback
1 Attach the Dock adaptor to iPod
connector port on the top panel of this unit.
• An iPod Dock adaptor is not supplied with
this unit.
When attaching the Dock adaptor, be sure to
orient the front-back directions of the Dock
adaptor correctly. To attach, first place the
protruding tabs on the front side of the adaptor
into the depressions on the iPod connector
port and press into position. When attaching
the adaptor, be careful not to strike the
connectors.
2 Connect your iPod.

Connecting your TV

To watch iPod images on a television, perform
connections using either a composite video
cable or component video cable.
• When using a component video cable for
connections, it is necessary to adjust the
unit's video output. See Setting the video
output below.
• When an iPod is connected to this unit, the
iPod's TV output setting is automatically
set to ON. While connected, the iPod can
be used to switch the TV output setting.
Caution
• Before making or changing the
connections, switch off the power and
disconnect the power cord from the power
outlet. Plugging in should be the final step.
Note
1 • This function is limited to iPod models providing TV output settings.
• When the iPod is disconnected from this unit, the iPod's TV output setting returns to its original state.
2 • Stop the iPod's video playback before adjusting the video output setting. The setting mode is disabled during playback and
pause.
• During the video output setting process, if no button operation is performed for 3 minutes, the setting will be canceled and
power will return to the standby mode.
10
En
Component
video cable
(commercially
available)
ADAPTER PORT
Setting the video output
Adjust the video output on this unit in
accordance with the method used to connect
2
the television.
• Default setting: Composite
INPUT
1 Switch the unit into standby.
1
2 Press and hold INPUT on the remote
control for three seconds.
The iPod indicator will flash two times, and the
video output will switch to Component. When
step 2 is repeated again, the iPod indicator will
flash one time, and the video output will switch
to Composite.
TV
Composite
video cable
(commercially
available)
VIDEO 2 MONITOR OUT VIDEO 1
Y P P AUDIO IN
B R
COMPONENT VIDEO