When The Oven Is Working; Interrupting A Cooking Cycle; Altering Parameters; Cancelling A Cooking Cycle - Pando PHC9300 Manual De Instrucciones

When the oven is working...

Interrupting a cooking cycle

You can stop the cooking process at any time by
pressing the Stop key once or by opening the
oven door.
In both cases:
 Microwave
immediately.
 The grill is de-activated but is still very hot.
Danger of burning!
 The timer stops and the display shows the
remaining amount of operating time.
If you wish, at this time you can:
1. Turn or stir the food to ensure it will be
evenly cooked.
2. Change the process parameters.
3. Cancel the process by pressing the Stop
key.
To restart the process, close the door and press
the Start key

Altering parameters

The operating parameters (time, weight, power,
etc.) can be altered when the oven is operating or
when the cooking process has been interrupted
by proceeding as follows:
1. Press the OK key – the duration flashes.
2. Turn the Rotating knob in any direction.
3. Press the OK key again – the temperature or
power flash.
4. Change them turning the Rotating knob.
5. Press the OK key again to confirm.
emission is

Cancelling a cooking cycle

If you wish to cancel the cooking process, press
the Stop key twice.
In case the cooking process has been interrupted
and you want to cancel it, press the Stop key
once.
stopped
You will then hear a beep and the time will appear
on the display.

End of a cooking cycle

At the end of the process you will hear three
beeps and the display will show the word "End".
The beeps are repeated every 30 seconds until
the door is opened or the Stop key is pressed.
EN
20