Troubleshooting; Scrapping The Machine - Tennant 9001213 Manual De Uso Y Recambios

6.2 -TROUBLESHOOTING

FAULT CAUSE
The belt is broken
The reduction gear has
The main brush is
burnt out
not spinning
A wire is detached
The side brush is
The belt is broken
not spinning
The liquid is insufficient
(for lead acid battery)
The battery does
not stay charged
The terminal is loose
The filter is broken
The filter is in the wrong
Dust comes out
position
of the fan
The gaskets are worn
The brushes wear
The brushes are too low
out too quickly
The flaps are worn
Dust given off
while the
machine is in
Clogged filter
operation
The motor has burnt out
The vacuum
motor does not
The wire is disconnected
work
The battery terminals
are disconnected
The battery is
The machine
discharged
does not come on
NOTE
In case of other malfunctions, contact the
REMEDY
Replace
Contact service center
Contact service center
Replace
Top up
Tighten
Replace
Position correctly
Replace
Adjust
Replace
Clean
Contact service center
Contact service center
Check
Recharge
Authorized Service Center
Home Find... Go To..

6.3 -SCRAPPING THE MACHINE

In the event the machine must be scrapped, please remember
that batteries are not common waste materials. They must be
disposed of in accordance with the relevant laws.
The machine is composed of different parts. Dismantle it and
prepare the waste for disposal in accordance to their type.
DO NOT USE THE SCRAP PIECES AS SPARE PARTS.
KEEP SCRAPS OUT OF REACH OF CHILDREN.
15