Troubleshooting - Tennant VLX Manual De Instrucciones

PROBLEM
The machine raises dust.
The machine leaves dirt on the ground.
The main brush does not rotate.
The side brushes do not rotate.
The suction motor does not work.
The machine won't start
The batteries do not hold their charge.

TROUBLESHOOTING

CAUSE
Filter clogged.
Filter damaged.
Safety thermostat activated
The main brush has collected string or
wire.
Debris bin full.
Belt broken.
Fuse burned out.
Cable disconnected.
Reduction drive damaged.
Cutout tripped.
Microswitch faulty.
Cable disconnected.
Blown fuse.
Cable disconnected.
Motor damaged.
Safety thermostat activated
Blown fuse.
Cable disconnected.
Motor damaged.
Battery terminals disconnected
Batteries discharged
Emergency stop button pressed
No fuel
No engine oil
Driver detection device faulty
Operator not correctly seated.
Main fuse blown
No liquid
Loose terminal
EN
REMEDY
and if necessary remove and carefully
Remove the heat source from the debris
bin.
Remove the string and wire picked up.
Empty the debris bin
Contact customer service
Contact customer service
Check
Contact customer service
Contact customer service
Contact customer service
Check
Contact customer service
Check
Contact customer service
Remove the heat source from the debris
bin.
Contact customer service
Check
Contact customer service
Check
Recharge.
Reset.
Top up
Top up
Contact customer service
Sit correctly in the seat.
Contact customer service
Top up.
Tighten.
27