Song & Mute; Groove Check Function - Yamaha DTXPRESS II Manual De Instrucciones

© eighth note, ©3 eighth note (triplet),
˙ sixteenth note, ˙3 sixteenth note (triplet).
Use the note values to set the click tempo of the metronome.
r SONG
[Range] 1-127
Selects the song. The song number and song name will be dis-
played. Preset songs are numbered 1-95 and user songs are num-
bered 96-127.
The selected song will playback when the [>/I] button is pressed.
* When the rhythm mute ([SHIFT]+[PAGEs] is applied, the last
letter of the song name will be "˚".
* Refer to [About the Song] (P. 8).
* Refer to the [Preset Song List] (P. 49).
t Repeat Playback
[Range] -ß, »Å
Sets the repeat playback (repeat continuously from the beginning
to the end of the song) of the song.
When this parameter is set to "ȁ", the song will repeat playback.
When this parameter is set to "-ß", the song will playback nor-
mally.
3. Trigger Setup
This display is used for selecting the trigger.
TRIG ´´´´´´´´´´
1 Medium
w
q Velocity Meter
The input velocity for trigger inputs 1-10 is displayed using a bar
meter in the display.
w TRIG (Trigger Setup)
[Range] 1-9
Selects the trigger setup to be used. The trigger number and trig-
ger name will be displayed. Presets are numbered 1-5 and user
setups are numbered 6-9.
* For more information on the preset trigger setup, refer to the
[Trigger Setup List] (P. 49).
* Once a setting is changed in the Trigger Edit mode, "*" will ap-
pear between "TRIG" and "=" until the data is stored.
e Trigger Input Number
[Range] 1-10
This number indicates the trigger input number of the pad that
was last struck.
q
1
e

Groove Check Function

Function
As you play the pads along with a song, the DTXPRESS II
will compare your performance with its song clock and let
you know how accurate your timing is.
Display
In the Drum Kit Play mode (from any display) press the
[SHIFT]+[SEL>] (GRV) buttons.
* The Groove Check function will quit when song playback
is stopped.
GRV -----¨-----
Groov=0 Avg=0
q
q Groov (Groove)
[Range] –48 to 0 to +48
The difference in the timing of each stroke on the pad is dis-
played.
If the timing of the stroke is late compared to the just time, a
minus value will be displayed. If your timing is early, a plus
value will be displayed. If you timing is perfect, "0" will be
displayed.
w Avg (Average)
[Range] –48 to 0 to +48
This function displays the average value of your timing ac-
curacy after the Groove Check function is switched ON.
This function checks your performance on the entire drum
set and can check your performance on one song. The infor-
mation shown in the display is the same as in q Groov.
* To reset the data, press the [SHIFT]+[SEL>] buttons twice.
e Graph
Indicates the timing by means of a graph.
Drum Kit Play Mode
e
w
7